
Gyokucho Razorsaw Super Hard 06-240 Crosscut Saw
SKU: GY-410Barcode: 4903524041015
Summary
Gyokucho Razorsaw Super Hard 06-240: 240 mm spineless crosscut saw with a 0.6 mm blade and 1.5 mm pitch teeth. Rattan handle. Made in Japan.
Brand
Categories
Types
Description
The Super Hard 06-240 is the 240 mm model with a 0.6 mm blade and fine 1.5 mm pitch teeth (about 17 per inch), cutting a 0.9 mm kerf. Without a spine there is no limit on depth of cut, so it will go through a 2x4 or a wide board in one pass while still leaving a surface clean enough for finish work. The rattan-wrapped handle weighs almost nothing.
Super Hard is Gyokucho's general-purpose single-edge saw for carpentry: a stiff 0.6 mm blade with no spine, so it cuts as deep as you need, and crosscut teeth that handle both softwood and hardwood. The teeth are impulse hardened, an electrical heat treatment that makes the cutting edges much harder than the body of the blade, so they stay sharp far longer than conventional teeth. When the teeth finally dull, the blade is replaced rather than sharpened; a fresh blade restores the saw to new condition at a fraction of the cost of a new saw; the blade is held in the handle by a single screw that can be loosened with a coin, so changing it takes a minute.
Product features
- Type: single-edge (kataba) crosscut saw, no spine
- Blade length: 240 mm
- Blade thickness: 0.6 mm
- Kerf: 0.9 mm
- Teeth: 1.5 mm pitch (about 17 tpi), crosscut
- Handle: traditional rattan-wrapped wooden handle
- Replacement blade: Razorsaw S-410
- Weight: 190 g
- Made in: Japan
You may also like


































